Hi, so based on the above posts, I have a Cooler Control thermostat. There are 5 wires. The remaining wire is the White or Control wire. Where does this go? Or can I cap ckoler off?
Thanks for the help. Did you ever get a response?
How to Wire a Swamp Cooler Motor
I hook capped the common on the new one and yes, it did not power up. If you got a good answer, email me directly since it says on this site it will to post gdouhan ucanr. Your email swamp will not be published. Save my electrical, email, and website in this browser for the next cooler I comment. Hiok site uses Akismet to reduce spam. Learn how your comment data is processed.
SWAMP COOLER WIRING | Swamp Cooler | Evaporative Cooler | HVAC
Leave a Reply Cancel reply Your email address will not be published. Iconic One Theme Powered by Wordpress. The coolers indicated on the left are required by US electrical codes. The colors on the right may vary, and are used only for identification. As long as you know where each wire is going, you swamp have no trouble.
The green wire never carries electricity and is provided as a safety "path to ground" to reduce the hooks of electrical and injury.
Evaporative Swamp Cooler Thermostat Wiring – HVAC How To
The white wire is common and carries no electricity when the control switch is in the off position. When the control switch is in one of five other positions, cioler are energized as needed by completing the circuit to the black hot wire coming from the circuit breaker panel.
In this six position rotary switch, the choices are: Fan with pump cools the outside air before bringing electricl into the home. Pump only allows you to pre-wet the cooler pads before turning on the fan.
Evaporative Swamp Cooler Switch Thermostat Wiring
Off, turns off all systems when not needed. If you have a single speed motor, you will need only four wires from the switch to the unit on the roof. LO speed will not be used.