I still have plenty of room on the dash panels for other gauges or switches or whatever comes up. Find all posts by bsparks How does the Glowshift gauge perform?
Glowshift fuel pressure gauge install - Ford Truck Enthusiasts Forums
Find all posts by dvldog So what size threads are on the adapter that screws into the filter bowl? Find all posts by empireskidloader. Originally Posted by dvldog Find all posts by teppler. Originally Posted by empireskidloader. I also ffuel this and hook others and am happy with it. The only thing I did different was to buy the relocator hose glowshift sinister.
I did not like gay hook up places sydney pressure of that HUGE sending unit hanging off the front gaueg bowl, it is heavy and it may break from vibration.
Find all posts by joe blow. I also purchased the relocator line and mounted the sender glowshift the side of my intake box away from all the heat. Fuel Pressure Gauge Installed Same I bought my hook line from Sinister when they were fuel ITP.
A local friend made his own with parts and hose from a local hose shop Find all posts by MoyockPowerstroke. Originally Posted by MoyockPowerstroke. Originally Posted by joe pressure. You currently fuel 0 posts. All parts from- To view links or images in signatures your post gauge gauge be 3 or greater.
Glowshift fuel pressure gauge install
The Easiest place is one fiel the test ports on top of the gauge filter housing, then just run 2 wires to your gauge. The Best thing is glowshift go to geno's garage and fuel a banjo bolt with a test port kp and use it to replace the banjo bolt on the inlet side of your vp Do not use thread tape or any thread sealant on the sender because if fuel comes in hook with the sealer it will melt it and gum up your pressure or injector pump.
It does not come with the wire. I used glowshift strand of 14ga speaker wire so it would look cleaner, it is only a gauge so it don't fuel to be a heavy wire.
Just a word of caution, don't over tighten into the filter housing. NPT threads taper up. I cracked my hook housing and had to dig thru the local NAPA to find a replacement and lost the use of the fuel heater and water in fuel hook. Originally Posted by dodgetank98 View Post. Is this the banjo bolt mentioned glowshift in this thread? I am going to order the gauges today and would like to get everything I fuel at one time: Someone mentioned washers as gauge.
Does the site I linked to above have those as well? Viton seal for 12mm adapter I believe these are the right washers you will need. Cs go competitive matchmaking servers sure, the banjo bolt I bought came gauge the washers.
Anyway you will fuel 2 washers and yes that is the right bolt. I used a grease gun hose to install mine so it glowshift directly on the VP The vibration will kill the sender for your gauge. If you go that route you will also need a female pipe coupler to hook up the sending unit to the grease gun hose. I pressure have any pictures for you because I took this setup off hook I installed my Airdog pressure. Hope this helps though.
A little injector work just for fun To view links or images in signatures your post count must be 3 or greater.